9608200339 head lamp compatible with MERCEDES-BENZ ACTROS MP4

9608200339 head lamp is a precision-engineered replacement head lamp assembly for vehicles compatible with MERCEDES-BENZ ACTROS MP4 applications where the OE reference matches. It is often selected when a cracked lens, fogged housing, or vibration damage causes unstable output and inconsistent aim. Fitment should be confirmed by OE reference and mounting configuration before ordering.

The 9608200339 head lamp is built for commercial use with moisture ingress protection, an impact-resistant housing structure, and reflector geometry designed for predictable beam pattern behavior. Controlled dimensional tolerances at the bracket points support beam cutoff control in low-light working conditions, wet-weather routes, and depot maneuvering.

During installation, the 9608200339 head lamp is intended to support direct-fit replacement when guide pin alignment, mounting points, and the sealed connector interface match the removed unit. Technicians typically check wiring harness match, inspect for burnt connector pins, and confirm stable seating before a final aiming adjustment for regional distribution trucks and long-haul route operation.

For fleet inventory planning, keep the OE reference 9608200339 recorded and confirm side configuration by mounting layout before ordering. Stocking the 9608200339 head lamp improves warehouse picking accuracy and reduces downtime during scheduled lighting checks.

• OE-based SKU consolidation supports faster warehouse picking and workshop kitting
• Clear identification helps reduce receiving errors across multi-vehicle service schedules
• Packaging suitable for pallet handling helps protect lens surfaces and mounting points
• Useful for planned inspections and preventative maintenance in fleet operations
• Supports RH/LH pairing strategy when operators service symmetrical lighting sets

1. Park safely, apply the parking brake, and disconnect the battery.
2. Confirm OE reference 9608200339 and compare the mounting layout to the existing unit.
3. Remove surrounding trim if required and note the current beam aim reference.
4. Unfasten the lamp, then unplug the connector without pulling the wiring harness.
5. Inspect brackets, adjusters, and connectors for corrosion, cracks, or heat marks.
6. Install the replacement, align guide points, and tighten fasteners evenly.
7. Restore power, test functions, and perform a final beam aim check.

No special tools are required in most workshop scenarios. Fitment should be confirmed by OE reference and mounting configuration before ordering.

This replacement lighting assembly is designed for commercial-vehicle service with emphasis on stable mounting geometry, sealing integrity, and predictable optical alignment when configuration matches.

Fitment should be confirmed by OE reference and mounting configuration before ordering.

Compatible with MERCEDES-BENZ ACTROS MP4 / ANTOS / AROCS applications where OE reference matches.