9608200556 fog lamp RH compatible with MERCEDES-BENZ ACTROS MP4

9608200556 fog lamp is a precision-engineered replacement designed for the right-side (RH) bumper position on trucks compatible with MERCEDES-BENZ ACTROS MP4 front-end configurations where the mounting layout matches. Based on OE reference 9608200556, this unit is commonly chosen when the lens is stone-chipped, the housing fogs due to moisture ingress, or the lamp output becomes uneven in spray and low-visibility conditions.

The 9608200556 fog lamp focuses on durability for commercial-vehicle duty: an impact-resistant lens interface, a rigid housing to hold dimensional tolerances, and sealing surfaces intended to reduce water and dust contamination around the reflector cavity. Consistent bracket geometry helps maintain stable beam direction during depot maneuvering, wet roundabouts, and long-haul night driving where low-position illumination supports edge definition.

Installation of the 9608200556 fog lamp is intended to be direct-fit when the connector interface and guide points match the removed lamp. Remove the fasteners, release the connector lock tab, and verify the unit sits flush before final tightening to avoid stressing mounting tabs. Technicians typically inspect the harness pins for corrosion or heat marks, confirm the bumper opening is not distorted, and then complete a functional check to ensure steady illumination.

For fleet planning, record OE 9608200556 in service logs and confirm RH orientation by the mounting shape before ordering. Keeping this fog lamp available reduces downtime during scheduled inspections and seasonal visibility checks, especially for tractors and rigids running mixed urban and motorway duty cycles. Fitment should be confirmed by OE reference and mounting configuration before ordering.

• OE-referenced SKU consolidation supports faster picking, kitting, and workshop scheduling
• Clear part identification helps reduce receiving errors across multi-vehicle maintenance programs
• Packaging designed for warehouse handling helps protect lens edges and mounting tabs in storage
• Suitable for fleet preventive maintenance cycles and seasonal visibility inspections
• Supports RH/LH pairing strategy when operators standardize lighting service intervals

1. Park safely, apply the parking brake, and disconnect the battery.
2. Confirm OE 9608200556 and compare the mounting layout to the removed lamp.
3. Remove the access trim or lower cover as required for your bumper configuration.
4. Unfasten the lamp while supporting the housing to avoid stressing the mounting tabs.
5. Disconnect the harness connector using the lock tab—do not pull on the wiring.
6. Clean the mounting surface and inspect for impact deformation, corrosion, or cracked brackets.
7. Install the replacement, hand-start fasteners, and tighten evenly to ensure flush seating.
8. Reconnect the battery and test illumination before final reassembly.

Most workshops can complete the swap with standard hand tools. Fitment should be confirmed by OE reference and mounting configuration before ordering.

This replacement fog lamp is designed for commercial-vehicle service with durability-focused materials, sealing-oriented interfaces, and stable mounting geometry when configuration matches.

Fitment should be confirmed by OE reference and mounting configuration before ordering.

Compatible with MERCEDES-BENZ ACTROS MP4.