596000004001 mirror main body RH – Compatible with ACTROS MP4 / ANTOS / AROCS

596000004001 mirror main body is a right-hand (RH) mirror housing core designed for stable mounting and consistent mirror alignment on trucks compatible with MERCEDES-BENZ Actros MP4, Antos, and Arocs when the OE reference and mounting configuration match. Fitment should be confirmed by OE reference and mounting configuration before ordering. This mirror main body is typically replaced after depot maneuvering contact, vibration damage, or stress around mounting tabs that can cause looseness, rattling, and shifting mirror angles in high-mileage service.

Built around an impact-resistant housing concept, the assembly focuses on dimensional tolerances at the bracket interface and seating geometry where the shell, caps, and internal supports meet. Using the correct 596000004001 mirror main body helps reduce misalignment that may lead to wind noise, uneven gaps, or accelerated wear at clip points. For accurate warehouse picking and service records, reference the OE number 596000004001 consistently across RFQs and bin labels.

During installation, technicians usually compare the removed part to the replacement by checking guide pin alignment, fastening positions, and any wiring harness match requirements for the mirror assembly configuration. A properly seated 596000004001 mirror main body supports a stable mounting bracket feel under vibration and helps maintain moisture ingress protection at the seating line, especially in wet operations and low-light working conditions.

For fleet inventory planning, RH/LH stocking is often used to reduce downtime after yard incidents. If you are pairing sides, confirm the opposite-hand configuration separately to avoid mix-ups caused by similar outlines across model updates. The 596000004001 mirror main body is intended as a direct-fit service replacement when the reference and mounting points match, supporting reliable upkeep for regional distribution trucks and long-haul route operation.

• SKU discipline: keep 596000004001 on labels to improve warehouse picking accuracy for similar mirror housings.
• Fleet maintenance readiness: supports planned exterior repairs and fast turnaround after yard-contact incidents.
• Packaging handling control: single-unit boxing helps reduce scuffing and deformation during internal transfers.
• Stable aftermarket supply intent: supports consistent replenishment cycles for distribution centers and workshops.
• SKU pairing (RH/LH): simplifies stocking strategies when mirror assemblies are serviced in matched sets.

1. Park safely, apply the parking brake, and disconnect the battery if the mirror assembly includes electrical routing.
2. Support the mirror assembly to avoid strain on the bracket during disassembly.
3. Remove fasteners evenly and note each fixing position for reassembly.
4. Unclip covers as needed and inspect the seating line for cracks or distortion.
5. Check guide pin alignment areas and confirm the bracket faces are clean and flat.
6. Compare the removed housing to the replacement to confirm RH orientation and mounting points.
7. Install the new main body and tighten in sequence to prevent twist.
8. Confirm seal integrity around seating edges for moisture ingress protection.
9. Re-check stability under gentle hand pressure and after a short vibration test.
10. Record the OE reference 596000004001 in service history for repeat ordering.

This service replacement supports direct-fit installation with plug-and-play compatibility depending on the mirror assembly configuration, and no special tools required for standard workshop procedures.

This page is provided for aftermarket identification and service replacement based on OE reference matching and verification of the mounting configuration on the vehicle. Fitment should be confirmed by OE reference and mounting configuration before ordering.

• Material performance: designed around an impact-resistant housing intent with stable seating geometry for commercial vehicle use.
• Installation compatibility: engineered for compatibility when mounting points and bracket interfaces match the vehicle configuration.
• Reference coverage: OE reference 596000004001 is used for identification and picking.
• Brand usage: brand names are used only to indicate compatibility context.

Compatible with MERCEDES-BENZ Actros MP4, Antos, Arocs.