9607200614 door extension support – Compatible with ACTROS MP4

9607200614 door extension support is a precision-engineered replacement bracket designed to support the door extension / outer trim area on the LH side, helping restore clean panel gaps and secure retention. Referencing OE numbers 9607200614 (LH) and 9607200714 (RH counterpart), this part is commonly used on applications compatible with MERCEDES-BENZ ACTROS MP4 where door-side trims can loosen after vibration, minor contact, or repeated wash cycles.

The 9607200614 door extension support is typically manufactured with an impact-resistant, corrosion-aware structure and reinforced mounting points to help maintain dimensional tolerances under long-haul vibration and stop-start urban duty. Consistent hole spacing and stable edge geometry help reduce rattles, prevent uneven load on clips, and limit stress marks that often appear when the door extension is not seated squarely.

During installation, the 9607200614 door extension support is generally a direct-fit replacement: remove the affected trim, clean the contact surfaces, then align the bracket to the mounting interface and tighten fasteners evenly. A correct connector / harness clearance check (where applicable) and careful bracket alignment help avoid rubbing marks and reduce the chance of premature clip fatigue on distribution trucks and tractors operating in mixed weather.

For workshop picking accuracy and fleet stocking, keep LH/RH parts separated and label both OE references clearly—9607200614 and 9607200714. Technicians often inspect the opposite-side support when one side is damaged, since door extension hardware is frequently exposed to similar vibration loads and curb-side impacts across route cycles.

• OE-referenced labeling supports fast cross-checking and reduces mis-picks across multiple depots.
• Protective packing helps reduce edge scuffs and deformation around mounting points during transport and shelving.
• Consistent identification supports planned bodywork refresh cycles and accident-repair staging workflows.
• Clear LH/RH kitting workflow helps standardize workshop staging and shorten turnaround time.
• Reliable SKU mapping supports receiving, put-away, and route-based replenishment planning.

1. Prepare: Park safely, apply the parking brake, and switch off ignition. Disconnect the battery if working near wiring routes.
2. Access: Remove the door extension / adjacent trims to expose the support mounting area.
3. Remove: Release fasteners and clips evenly to avoid cracking surrounding trim sections.
4. Inspect: Check mounting holes, clip seats, and contact surfaces for distortion or trapped debris.
5. Install: Align the new support, tighten fasteners evenly, and confirm trim seating without preload.
6. Final check: Verify even gaps, no rubbing during door movement, and stable retention with no rattle.

Summary: Direct-fit replacement when OE reference and mounting configuration match—focus on clean seating surfaces and accurate alignment for long-term stability.

This part is produced for commercial vehicle body repair use with attention to mounting geometry, material stability, and retention performance for vibration-prone, weather-exposed operation.

• Verify fitment using OE reference and mounting configuration prior to ordering and installation.
• Designed to support stable trim retention and consistent door-side panel alignment.
• Install using standard workshop safety practices and vehicle service procedures.

Compatible with MERCEDES-BENZ ACTROS MP4.