9608113007 is a mirror cover used as a service replacement for exterior mirror assemblies on vehicles compatible with MERCEDES-BENZ Actros MP4, Antos and Arocs when reference and mounting configuration match. Fitment should be confirmed by OE reference and mounting configuration before ordering. For correct identification, use the highlighted OE references 9608113007 and A9608113007 in purchasing, picking, and service records.

In fleet operation, mirror covers are commonly replaced after low-speed yard contact, stone impact, cracked surfaces, or clip fatigue that creates looseness and vibration noise. A properly seated 9608113007 cover helps restore a clean mirror finish, protects underlying housing edges from road spray, and reduces the risk of uneven gaps caused by misaligned retention points. Keeping 9608113007 clearly referenced on RFQs also improves warehouse picking accuracy when multiple mirror variants share a similar profile.

During installation, technicians typically clean contact faces, inspect for damaged tabs, and align retention points progressively so the cover sits flush without twist. For best results, verify the cover profile and clip locations against the mirror housing before final seating, then perform a short vibration check to confirm stable fitment of 9608113007 under wind load.

Packaging is prepared as 2 units per box, with a listed packing weight of 1.08 kg. This supports predictable handling for workshop stock and distributor logistics across compatible model fleets.

• Box efficiency: 2 units per box helps streamline workshop issuing and reduces packaging waste.
• OE-led labeling: mark shelves with 9608113007 and A9608113007 to reduce picking errors.
• Predictable handling: listed packing weight 1.08 kg supports consistent internal transfer routines.
• Downtime control: dedicated cover stock improves turnaround after yard scuffs and minor mirror-area impacts.
• Fleet planning: suitable for model coverage compatible with MERCEDES-BENZ Actros MP4, Antos and Arocs.

• Common symptoms: cracked cover, loose seating, rattling at speed, or visible gaps around the mirror housing.
• Preparation: park safely, switch off ignition, and protect surrounding painted surfaces.
• Removal: release retention points evenly to avoid breaking tabs or stressing the mirror housing.
• Inspection: clean contact faces and confirm all mounting tabs on the housing are intact.
• Install: align clips and press progressively until the cover sits flush without twist.
• Final check: perform a short vibration check and record 9608113007 for repeat ordering.

Fitment should be confirmed by OE reference and mounting configuration before ordering.

• Use intent: designed for commercial vehicle mirror system protection and exterior finish restoration.
• Installation compatibility: confirm cover profile, clip locations, and housing interface before final seating.
• OE references covered: 9608113007, A9608113007.
• Service scope: intended for replacement where cover damage affects fitment, noise control, or mirror housing protection.

Compatible with MERCEDES-BENZ Actros MP4, Antos, Arocs.